Skip to main content

VAAPR Maintenance

The VAAPR bed is an engineered surface, with a material and texture optimized for 3D print auto-ejection. We invented this surface, going through over 20 formulations until we found an optimal balance between adhesion while hot, and release after cooling.

1. How to clean your VAAPR bed (Video Tutorial)

The VAAPR bed works best when it is clean and free of dust or oils.

Once it is clean, you should only need to clean it occasionally, since the VAAPR bed is self cleaning. Your will soon be auto-ejecting parts, so you won't need to touch the bed directly, and you'll only have to wipe it down once every few months.

Warning

Do not apply isopropyl alcohol, acetone, or any other cleaning solutions to the VAAPR bed.

Most cleaning products irreversibly damage the print surface!

ONLY clean the VAAPR print bed with unscented dish soap and water. We recommend Seventh Generation Dish Soap.

VAAPR bed cleaning instructions:

  1. Apply 1-2 drops of unscented dish soap to a clean, damp cloth or paper towel. As of September, 2022, all VAAPR beds come with a small bottle of Seventh Generation Dish Soap which should be enough to clean the bed 30 times.
  2. Wipe the entire bed thoroughly with the soapy cloth.
  3. Rinse the bed down using another clean damp cloth or paper towel. Make sure there is no soap residue left on the bed.
  4. Use a dry towel to dry the bed.

2. How to avoid damaging your VAAPR bed

  • Level the bed, and calibrate Z offset! Do this whenever you make significant mechanical changes to your printer, or whenever you update firmware.
  • Do not use metal scrapers or blades to remove parts from the VAAPR bed. Metal objects will permanently scratch the surface.
  • Do not try to remove prints while the bed is still hot. This may cause the VAAPR bed to flex and separate from the underlying adhesive, creating an uneven print surface.

3. How to remove a VAAPR bed

We hope you never have to do this, but here are the instructions just in case.

What you'll need:

  1. Puncture-resistant work gloves
  2. Safety goggles
  3. Goo Gone Adhesive Remover (optional)

How to remove VAAPR:

  1. If you have a removable flex plate, remove it from the printer. If not, place your 3D printer on a sturdy table and clamp it to the table if possible.
  2. Heat the bed to 55°C (ignore this step for removable flex plates).
  3. Pry up one corner of the VAAPR bed with a putty knife, print bed scraper, or flat-head screwdriver.
  4. Continue to pry up the bed until you can grip it with your hands. Apply Goo Gone into the crack between the VAAPR and the underlying surface to make this easier.
  5. Peel the bed off. This will require significant force. Goo Gone helps, but it will take time to seep into the crack between the VAAPR and the underlying surface.
  6. Remove any residue from the underlying surface. Apply Goo Gone, let it sit for a few minutes, and then scrape it off with a putty knife, 3D print scraper, or a razor blade.