Quick Start Compatibility Checklist
If you can check all the boxes below, you're ready to get started with AutoFarm3D.
- Your 3D printers are compatible with AutoFarm3D (See list below)
Recommended 3D Printers
- Prusa MK3/S/+
- Prusa MINI
- Artillery Sidewinder X1/X2
- Artillery Genius/Pro
- Creality Ender 3 S1
- Creality Ender 3/Pro/V2
- Creality CR10/V2/V3
Not an exhaustive list
These are just the 3D printers that have been tested and verified to work with AutoFarm3D. If you have an FDM printer running on Marlin 2 that is not on this list, please contact us to see whether it is compatible.
- Your slicer is compatible with AutoFarm3D (See list below)
Compatible Slicers
Most slicers are compatible with AutoFarm3D. If you're using one of the slicers below, you're good to go!
- Cura
- Simplify3D
- PrusaSlicer
- SuperSlicer (needs minor fix, see below)
SuperSlicer Compatibility Fix
In order for AutoFarm3D to successfully read SuperSlicer gcode, please add the following line to the "Before Layer Change" custom gcode:
;LAYER:{layer_num}
- Your 3D printers run Marlin 2 firmware.
- You have stable internet access via ethernet.
- Your hubs are connected to a clean power supply with no power dips or surges.
UPS Recommended
A UPS is highly recommended because brief power dips can cause your hubs to reboot, stopping all prints currently in progress.
- You have a Raspberry Pi 4 (2GB+) or a Print Farm Hub.