Skip to main content

CR10S Pro/V2

Compatibility information
  1. Update Firmware: Make sure your firmware is a version of Marlin 2

  2. Remove SD Card: Remove the SD card from the printer. When plugged in, it can interfere with the connection stability.

  3. Set Printer to Automated Mode: Please follow the instructions here to set your printer to automated mode.

To Be Discontinued

Starting 2024, we will be no longer provide tilt kits for CR10S Pro/V2

1.0 What's in the Kit

Printed Parts

  • 1 x Tilt Bracket Left (SP1)
  • 1 x Tilt Bracket Right (SP2)

Hardware

  • 2 x M5 x 60mm screws (can use 50mm for DIY and availability)
  • 2 x Rubber feet

2.0 What You'll Need

  • Allen Keys

3.0 Install Tilt Kit

  1. On an open and clean table, rotate your CR10 S Pro (V2) on it’s right side to give you access to the z-gantry bolts underneath.

    Flip e3s1

  2. Remove the outermost z-gantry screw.

  3. Using the provided M5x60mm bolt and M5 washer, install the SP1 tilt bracket.

  4. Ensure that the flat ledge of the tilt bracket is flush with the base of the 3D printer. See below for example. tilt Sw

  5. Carefully rotate your 3D printer on its left side and repeat step 2 using the SP2 tilt bracket.

  6. Rotate your 3D printer and let it stand using the tilt brackets.